Restoring Limestone Tiles Sealed With Brown Wood Sealer in Tewksbury

Slightly different story for you below; this time from the medieval town of Tewksbury which dates all the way back to the 8th century. A customer there had asked if there was anything that could be done to restore the appearance of their polished Limestone kitchen floor on which he had previously applied a wood sealer which had turned the tiles brown.

I inspected the floor and ran a test clean on a small section of tile which successfully removed the wood seal. This gave the customer the confidence to book me into to complete the job which I estimated would take three days to strip off the old sealer, deep clean and reseal with a more appropriate product.

Limestone Tiles Sealed With Brown Wood Sealer before restoration in Tewksbury

You probably can’t appreciate how bad the tiles looked from the photograph above but if you look at the indicated area under the kitchen units where the kick boards have been removed you can really see how the brown stain in the wood sealer has darkened the look of the tile.

Removing Old Sealers from Limestone Kitchen Floor

On the first day I prepared the area by removing the kick boards from the underneath the kitchen units so they wouldn’t get affected by the cleaning process and started wetting the floor with water. The water lubricates the burnishing process whereby coarse diamond encrusted pads are applied to the floor with a buffing machine. We started the process using a very coarse 100 grit milling pad to remove the wood sealer before moving onto the finer pads from 200 grit, 400 grit, 800 grit and finally 1500 grit pad building the finish of the floor as we progressed. The floor is rinsed with water between pads and the slurry is removed using a wet vacuum.

This burnishing process took up all of the first day so the next day I returned to focus on the edges I had missed and the grout lines, being a relatively small format tile for Limestone there was a lot of grout to cover. I tacked the grout lines with Remove and Go which is a powerful stripper and cleaning agent which is applied along the grout line and then scrubbed in with a narrow stiff brush before being rinsed away with water. The edges were treated with a set of small six inch milling pads fitted to a hand held buffing machine in a similar process as on the first day.

Sealing a Limestone Tiled Floor

On the third and final day the floor was spray burnished which a process is involving a very fine 3,000 grit floor burnishing pad and a little water spayed onto the floor during the application. This process really tightens up the pores in the stone and restores its appearance.

After making sure the floor was free of any lose grit I then proceeded to seal the Limestone with Tile Doctor Ultra Seal which is a natural look sealer that doesn’t alter the appearance of the stone but penetrates into the pores of the stone to protect it from within. I left it to dry for an hour then buffed the floor with a white buffing pad before apply a second coat. This was also left to dry for an hour before running the buffing pad over for a last time.

Limestone Tiles Sealed With Brown Wood Sealer After restoration in Tewksbury

It took a fair amount of work to get the floor looking back the way it was meant to be but I’m very pleased with the outcome and more importantly my customer was really happy.

Limestone Tiles Sealed With Brown Wood Sealer After restoration in Tewksbury

 
 

Professional Limestone Floor Polishing and Sealing in Gloucestershire

Rejuvenating Salvaged Flagstone Tiles at a Property in Ledbury

Here we have an interesting situation in which an old Flagstone tiled floor had been salvaged from a cottage approximately 30 years ago and subsequently reinstalled at a house in Ledbury, a small market town which lies to the west of the Malvern hills in the North of Gloucestershire. Since being reinstalled, the Flagstone tiles had been barely touched in terms of maintenance for three decades and so the stone and grout were naturally in need of a deep clean and seal!

Salvaged Flagstone Floor Before Restoration in Ledbury

The property owner had heard about the natural stone tile restoration services Tile Doctor provides and so booked me in to see what could be done to improve the condition of his floor.

Salvaged Flagstone Floor Before Restoration in Ledbury

Cleaning a Dirty Flagstone Tiled Floor

My first job in the cleaning process was to distribute a mixed solution of two cleaning products across the floor. These products were Tile Doctor Remove and Go, which is a multi-purpose stripper designed to remove old coatings and sealers, as well as any adhesive and paint stains, and Tile Doctor NanoTech HBU, a powerful cleaner which utilises nano-sized particles to penetrate difficult-to-reach areas of the stone to eliminate deep lying dirt and stains.

This potent cleaning solution was left to dwell on the surface of the floor for 45 minutes before being worked deep into the stone with a poly brush fitted to a buffing machine. The resultant cleaning slurry was then hoovered up with wet-and-dry vacuum. Next, the floor was rinsed and cleaned with just clean water and the slurry was once again hoovered up.

Salvaged Flagstone Floor During Cleaning in Ledbury

This left the tiles clean and fresh, so I turned my attention to cleaning the grout lines in detail, which also involved spot cleaning any stubborn grout smears with Remove and Go and Tile Doctor Acid Gel, which is a blend of Phosphoric and Hydrochloric acids in gel form designed to remove stains of this kind.

When satisfied with the result of the cleaning process, I rinsed the floor for a final time with fresh water, hoovered up as much moisture as possible with a wet vacuum and left the stone to dry off fully overnight.

Sealing a Flagstone Tiled Floor

On arrival at the property the following day, I checked the floor for dampness with my damp meter. The test proved that no excess moisture was present, so I proceeded to give the Flagstone a fresh seal.

With regards to sealer choice, the customer had requested a natural-looking matte finish to match in with the rustic characteristics of the Flagstone, so I used Tile Doctor Colour Grow – which provides exactly that. Colour Grow is a durable impregnating sealer that also enhances the natural shades in the stone to really bring the whole floor back to life. Roughly an hour was left between the application of each coating of sealer to allow the floor dry before applying the next.

Salvaged Flagstone Floor After Restoration in Ledbury

The result was a noticeable improvement in the condition and appearance of the Flagstone – and the customer couldn’t have been happier. It’s always satisfying to breathe some new life into old natural stone tiles.

Salvaged Flagstone Floor After Restoration in Ledbury

 
 

Professional Restoration of a Reclaimed Flagstone Tiled Floor in Gloucestershire

Ceramic Tiles and Grout Lines Rejuvenated in a Westmancote Hallway

This customer who lives in the old picturesque village of Westmancote, Gloucestershire asked me to do a home survey on their ceramic kitchen tiles which had been laid around fifteen years prior. With the exception of general cleaning not much had work had been done to the tile and grout and now the tiles were looking dull and the grout had turned black.

Ceramic Tiled Floor Westmancoate before cleaning

As part of the survey I ran a test clean on part of the floor and the tile and grout came up really well which convinced the customer to give me the job and I was soon booked in to return to complete the floor and work my magic.

Ceramic Tiled Floor Westmancoate before cleaning Ceramic Tiled Floor Westmancoate Cleaning Grout Lines

Deep Cleaning Ceramic Tile and Grout

The first job was to give the floor a sweep to remove any grit and then I set about cleaning the grout lines. The grout had trapped a lot of dirt so I decided to start with the application of Tile Doctor Remove and Go which is a strong cleaner/stripper that is safe to use on all types of tile and grout. The Remove and Go was left to soak into the grout for about ten minutes before being scrubbed in with a stiff grout brush. This process released the dirt and the now soiled solution was rinsed away using water which was then extracted using a wet vacuum.

Next step was to turn my attention to the Ceramic tiles which needed a deep clean so this time I applied a medium dilution of Tile Doctor Pro-Clean, left to dwell for ten minutes then ran over the tiles with tan pad fitted to a rotary buffing machine. Once the floor was done I rinsed away the soiled cleaning solution with water and extracted with the wet vacuum.

Sealing Floor Grout

I find it’s always the grout that lets down the appearance of a Ceramic tiled floor which are usually fairly maintenance free, to guard against this I always recommend the grout is sealed. Given the condition of the grout in this case it was definitely a good idea as I’m sure it wouldn’t be long before it started to discolour again.

With this in mind I sped up the drying of the grout lines with a heat gun and once done I sealed the grout lines using Tile Doctor Ultra Seal applied carefully with a Pipette.

Ceramic Tiled Floor Westmancoate after cleaning Ceramic Tiled Floor Westmancoate after cleaning

The customer was pleased with the end result and left the following feedback via the Tile Doctor feedback system.

Very professional work. We were sold on it when he came to quote and did a small patch clean. Malcolm was able to come within a few days of confirming his price was acceptable and the job was done swiftly and to an excellent standard. We now have a new floor!
 
 

Professional Grout Cleaning and Sealing in Gloucestershire

Quarry Tiles From the 1850s Rejuvenated at a Church in Tewkesbury

Tewkesbury, the town and civil parish in Gloucestershire, is famous for the Tewkesbury Abbey, a Norman abbey church dating back to the 7th century so it has a lot of history and some very old buildings. Although not one of the oldest buildings in the town I was recently called to a small church in Tewksbury to restore the Quarry tiled entrance way dating back to the 1850s. The tiles had become very heavily ingrained with pigeon droppings, paint, cement, and general dirt over the years – and they were well past due for some professional attention.

Old Quarry Tiled Church Steps Before Cleaning Tewkesbury

Deep Cleaning Dirty Quarry Tiled Steps

My first job was to scrape away all the excess pigeon droppings and paint that could be removed by hand. Once the floor was clear, I was able to cover it with a strong solution of two of our cleaning products: Tile Doctor Remove and Go and Tile Doctor NanoTech HBU. While the cleaners are similarly powerful, they serve slightly different purposes.

Remove and Go is specially designed to strip away any old sealers, synthetic finishes, adhesives, cements, and paints. It also helps to draw old ingrained stains and remove heavy grease build-up. NanoTech HBU on the other hand is a penetrating cleaner designed to work where other cleaners won’t. It does this by utilizing nano-sized particles to reach underneath tough stains, dissolve them, and lift them out. Both products are suitable for use on polished and unpolished natural stone, including Limestone, Marble, Slate, Travertine and, of course, Quarry.

The cleaning solution was left to dwell for 45 minutes and then scrubbed into the tiles using a black pad fitted to a buffing machine. I then repeated this process with the same products to clean the grout lines. When I was happy with the overall cleanliness of the tiles, I spot cleaned some particularly stubborn stains using a steam cleaner in combination with a handheld scraper and some more NanoTech HBU.

Old Quarry Tiled Church Steps During Cleaning Tewkesbury

Sealing a Quarry Tiled Entrance Way

After finishing the cleaning process, I left the tiles to dry for two days. The tiles needed a good amount of time to dry completely because the old tiles don’t have the reasonably modern benefit of a damp-proof membrane.

Upon my return to the church I checked for any damp issues, and when satisfied that there weren’t any to deal with, I proceeded to seal the tiles using four coats of Tile Doctor Colour Grow. This is an impregnating sealer that enhances the natural colours in the Quarry tiles and provides the natural look, matte finish that the proprietor of the church had requested.

As you can see from the photo below, the result of the restoration was transformational. Needless to say, the parishioners will be very happy with the rejuvenated entrance way and, thanks to a highly durable sealant, the steps will be protected for the long term.

Old Quarry Tiled Church Steps During Cleaning Tewkesbury

 
 

Church Step Restoration in Gloucestershire

Dirty Victorian Hallway Tiles Rejuvenated in Tewkesbury

Victorian tiles are very hard-wearing and historically a popular choice for heavy traffic areas such as hallways. Still popular today they are nonetheless like most tiles and can become ingrained with dirt over time.

This particular floor, located in a property in the old market town of Tewkesbury is a good example of a floor that was in good physical condition, but heavily ingrained with dirt due to a lack of regular maintenance. At a loss for how to remedy the situation by themselves, the property owner asked me to pay a visit to restore the tiles back to their best possible condition.

Large Victorian Hallway Tewkesbury Before Cleaning

Cleaning a Dirty Victorian Tiled Hallway Floor

In this particular scenario, I opted to mix and apply a solution of different cleaning products from our professional range, each serving a different purpose. These products were Tile Doctor Pro Clean, Tile Doctor Remove and Go, and Tile Doctor NanoTech HBU. Remove and Go serves the purpose of stripping away any old sealer on the tiles, while Pro Clean is an alkaline cleaner that reliably removes dirt and staining. NanoTech HBU is a particularly powerful cleaner which utilises nano-sized particles to penetrate deep into the pores of the stone, get underneath difficult stains and lift them out.

I spread this potent solution across the length and width of the tiled hallway and left it to soak for approximately 10 minutes, before using a black scrubbing pad fitted to my buffing machine to give the tiles a deep scrub. Next, I rinsed the soiled solution away and neutralised the chemicals with plain water, before extracting any residue using a wet vacuum. I repeated the cleaning process several times to achieve the best results possible, and I also employed the aid of a steam cleaner to spot clean any particularly stubborn marks.

Sealing a Dirty Victorian Tiled Hallway Floor

Cleaning the floor took two days in total. At the end of the second day, I gave the floor a thorough and final rinse before leaving it to dry completely overnight. The next day, I returned to the property to seal the floor after checking the floor was dry. Ensuring before sealing that the floor is completely dry is crucial – even the smallest quantity of moisture remaining can potentially cloud the sealer and damage its performance.

My choice of sealer was Tile Doctor Colour Grow, an impregnating sealer that penetrates and fills the pores of the tile to prevent trapped dirt and makes regular cleaning much easier. Colour Grow is a great choice of sealer for Victorian tiles because it really enhances the colourful patterns which are characteristic of this type of tile.
My customer was very impressed with the service and remarked on the huge improvement to the appearance of the floor. You can see this for yourself – just take a look at the before and after photos!

Large Victorian Hallway Tewkesbury After Clean and Seal

 
 

Professional Victorian Tiled Hallway Restoration in Gloucestershire